Sump Pump Installation in Etobicoke
A sump pump is the powered outlet of a basement drainage system. Groundwater collects in a pit below the basement floor, and when the water reaches a set level the pump moves it out and away from the house.
Basement Waterproofing Etobicoke installs new sump systems, replaces failing pumps, and corrects discharge arrangements that send water straight back toward the foundation.
Getting a sump system right
Three things determine whether a sump system performs: the pit, the pump and the discharge. The pit needs enough volume that the pump is not cycling every thirty seconds. The pump needs capacity suited to the inflow, with a reliable float switch and a check valve to stop water flowing back into the pit. The discharge line needs to carry water far enough from the house that it does not simply return through the drainage system.
Discharge is the most commonly neglected part. A line that ends a foot from the foundation creates a loop where the same water is pumped repeatedly, keeping the pump running and the soil saturated.
Problems this service addresses
- No sump system in a basement that takes on water
- An aging pump nearing the end of its service life
- A pump that runs constantly or short-cycles
- Discharge that ends too close to the foundation
- Failed float switches and seized pumps
Potential benefits
Active removal of groundwater rather than passive hoping
A defined outlet for an interior drainage system
Reduced standing water beneath the basement slab
A base system that a battery backup can be added to
How the process works
Assess the basement
Water source, inflow volume, existing pit and available discharge routes are reviewed.
Set the pit
For a new system, a pit is excavated and set at the correct depth, tied to drainage where applicable.
Install pump and check valve
The pump, float and check valve are installed and the discharge line is run to a suitable outlet.
Test under load
The system is filled and tested so you can see the cycle and confirm the discharge point works.
Sump Pump Installation in Etobicoke
Sump pumps run hard in Etobicoke through the spring melt and after summer downpours, since clay soil releases water slowly and keeps the pit filling for days after the rain stops.
Discharge placement deserves particular attention on the narrow lots common in Mimico, New Toronto and Long Branch, where a poorly aimed discharge line can send water toward a neighbour's foundation as well as your own.
Serving homeowners throughout Etobicoke and surrounding areas, including Mimico, New Toronto, Long Branch, Alderwood, Islington, The Kingsway, Humber Bay and Rexdale. See all service areas.
Sump Pump Installation questions from Etobicoke homeowners
Ready to get started? Call 647-560-5653 or request an estimate online.
Call 647-560-5653Need sump pump installation in Etobicoke?
Contact Basement Waterproofing Etobicoke to discuss the problem, the likely cause, and the options available for your property.